Cervis TM70 Instrukcja Instalacji Pobierz pdf (Strona 16)

TM70Bi V3.1 (03/09) 1121174.pdf

IKUSI reserves the right to change this information without prior notice.

7.3 -

TROUBLESHOOTING

The transmitter and receiver have status monitoring LED’s, which help to identify irregularities.

The most common signals are contained in the tables below:

TRANSMITTER

LED

MEANS

Solid green

Transmitter transmitting normally. OPERATION mode.

Green pulses.

Transmitter ready for start-up. STAND BY mode.

Red slow flashing

Battery level low

Red fast flashing

Probably, EEPROM module is not plugged in.

Red double flashing

Transmitter cannot start up because a manoeuvre command is

present.

Solid red

Transmitter failure

RECEIVER

In OPERATION mode the 7 LED’s must be lit as has been previously described in section 4.3

Starting. If this is so, press the transmitter manoeuvre buttons and observe the response of the

output relays. If the response is normal, the problem is not related to the remote control

equipment and the installation must be checked. If any of the relays is not activated, the problem

is associated with the remote control equipment. If this happens, observe the appearance of the

LED’s:

LED

LIT

FLASHING

OFF

POWER

Power Supply OK

Power Supply not OK

HARDOK

Board OK

Slow: fault in the board

Fast: error in EEPROM

Fault in the board

SIGNAL

RF signal OK

RF signal detection in

SCANNING mode

The receiver is not receiving

RF signals

DATA

Is receiving the correct data

from a TM70

Signal received is not correct

ID Code OK

ID not recognised

ORDER

Any digital

manoeuvre ON

No digital manoeuvre ON

RELAY

STOP relays ON

STOP relays OFF

There are also two LEDs in the receiver (only available in LR72 electronic card) which informa

about the status of the CAN-BUS. If the CAN connection is not working, check the status of the

LEDs:

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 75 76

Komentarze do niniejszej Instrukcji

Brak uwag

Cervis TM70 Instrukcja Instalacji Strona 16

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Zdalne sterowanie Cervis TM70